Places to park electronics + computer PLA credits (BOG AAS + TESU AAS)

[bjcheung77]

With the 5-6 years and 10K/year...  My suggestion is the following for you:
Pierpont BOG AAS Mechatronics - Cost of transcripts - Get this done ASAP

TESU AAS Applied Computer and ASS Applied Electronics - Cost of associates capstone
TESU BSBA CIS/BACS or BS Tech Studies - Cost of two capstones, pla/transfer the rest if you can

For your grad, a Master's System Engineering and for a little less than 10K, ECPI - Mechatronics!
Link: https://www.ecpi.edu/programs/systems-en...ers-degree

This is how I would play things, Sophia.org for lower level requirements and general education, it's cheap, easy, fast and non proctored.  Make sure to use a second monitor to have the materials/resources open on the second screen.  For TESU, I suggest you do the 16-18 credits for residency instead of paying the residency waiver fee.  PLA will count for RA, but you still need the residency credits, total 30 RA credits required.  Take your time to get the job done properly and in an orderly, systematic fashion.

---

Actually, hmm... I was thinking, since you have so much time, you can probably get the credits and transfer them in using the least expensive options.  I would do the Coursera/TADA options here, 6 months all you can eat, after you do the Sophia.org courses for transfer to Pierpont BOG AAS with an emphasis...

Then you can take all you can eat courses from the Finnish Universities here and see if they can transfer into the TESU programs of choice, even a BSPr would do, you just need the "check box" and get into the master's program I just mentioned. Again, if you have the time, it's to build your certs, get the degree, and gain the experience...

Coursera/TADA offerings: https://degreeforum.miraheze.org/wiki/Coursera
Finnish Universities Wiki: https://degreeforum.miraheze.org/wiki/Fi...iversities